Basic remote operations can be performed in the IR mode. The remote uses two-way communication to the AT&T TV. RF mode eliminates the need for the remote and the paired devices to be in line of sight to each other. The RC82V Remote Control has a directional pad.
Similarly, Where is the IR sensor on AT&T Uverse box?
ATTU-verseCare. Hi glwobken! The IR sensor on the VIP1200 should be found next to the record LED. You can also use a flashlight to shine some light through the dark plastic to see its exact location.
Additionally, How do I pair my ATT TV remote?
Remote pairing
- Point the remote at your DIRECTV STREAM device.
- Press and hold FAST FORWARD and REWIND at the same time for 2-3 seconds. When they pair, you’ll get an onscreen message that your remote is ready to use.
How do AT&T remotes work?
Here’s all you need to do:
- With your TV on, use your U-verse TV remote and press Menu.
- Select Help > Information > Remote Control Setup.
- Next, select your remote control from the TV onscreen list. Refer to your specific remote for TV/device setup options.
- Select Top Ten Brand Setup, Automatic Code, or Manual Setup.
Why is my AT&T Remote not working?
Check the batteries – When you press the AT&T button located at the top of the remote control, the button should shine brightly. If the button does not shine, change the batteries. … Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart.
How do I reset my AT&T TV remote?
Step 4: How to Reset Your AT&T TV Remote
- Hold down the “Dash (-),” “Apps,” or “Diamond” buttons.
- Wait until you see the LED lights on your remote blink blue twice.
- Press and release the red button on the side of your AT&T TV device to restart it, or.
- Unplug your AT&T TV device then plug it back in.
How do I reset my AT&T remote control?
Reset your remote by type and clear any programming
- Press and hold the AT&T and the OK key simultaneously.
- Release both keys and all four mode keys will flash twice to indicate you are in programming mode.
- Enter programming code 900 by pressing the number keys on the remote control.
How do I get my volume to work on my AT&T TV remote?
Using your U-verse TV remote control:
- Press Menu.
- Scroll down to Help and press OK.
- Select Information > Troubleshoot & Resolve > TV > Sound.
- Select the Sound issue.
- Follow the onscreen prompts.