First rule, gang: Do not set wooden posts in concrete. Look, no matter what preventative steps you take (and I’ll get to those), eventually wooden posts rot, and eventually you’ll have to set new ones. Not only does burying them in concrete make for more work down the line, it actually can speed up the rotting.
– Set posts in concrete when stability is extra important. …
– Prepare your fence posts. …
– Dig a hole wider than the fence post. …
– Add a few inches of gravel. …
– Brace the post. …
– Repeat for each post hole. …
– Add more gravel. …
– Mix your concrete.
Subsequently, How do you attach fence posts to concrete?
Also, Is it OK to set deck posts in concrete?
There are several ways to set deck posts; we recommend attaching the posts to concrete footers above the ground. This helps to prevent wooden posts from rotting. Set footers a minimum of 6” below the frost line for your area to prevent movement during freezing temperatures.
How do you attach wood post to concrete?
Last Review : 5 days ago.
How do you attach a wooden post to concrete?
How do you protect wood from sitting on concrete?
Anyplace where wood meets the ground or concrete, the lumber must be pressure treated. For additional moisture protection, a gasket or strip of closed-cell foam can be installed between the concrete foundation and the sill plate.
Can pressure treated posts be set in concrete?
Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. … Concrete should be poured around the post – no concrete under the post.
Can you put wood directly on concrete?
Wood in direct contact with concrete, and the dampness often found there, will rapidly decay. To avoid this, use pressure-treated lumber. This is wood impregnated with decay-resisting chemicals, usually chromated copper arsenates. … However, pressure treating creates only a shell of protection around the wood.Mar 27, 1988
How long do treated posts last in concrete?
5 to 10 years
Can pressure treated wood sit on concrete?
YES. Any exterior concrete that is in contact with earth may wick moisture. Thus, it is required to place pressure treated wood directly against the concrete if one wishes next to build off that concrete with untreated wood.
How do you support a post to concrete?
Attach angled 2 x 4 braces to two adjacent sides of the post using one screw for each brace. Drive a stake into the ground near the lower end of each brace. 4. Use a level to position the post plumb (perfectly vertical), checking on two adjacent sides with the level, then fasten the braces to the stakes.
Can you put wood post in concrete?
First rule, gang: Do not set wooden posts in concrete. Look, no matter what preventative steps you take (and I’ll get to those), eventually wooden posts rot, and eventually you’ll have to set new ones. Not only does burying them in concrete make for more work down the line, it actually can speed up the rotting.
Can pressure treated wood go directly on concrete?
YES. Any exterior concrete that is in contact with earth may wick moisture. Thus, it is required to place pressure treated wood directly against the concrete if one wishes next to build off that concrete with untreated wood.
How long will pressure treated wood last sitting on the ground?
The Forest Products Laboratory and other research groups have shown that treated wood stakes placed in the ground for more than 40 years remain rot-free.
How do you anchor lumber to concrete?
The fastest and easiest way to attach most wood parts to concrete is to use a powder-actuated gun. To use it, load a special gun nail and a . 22 caliber gun shell into the barrel. Press the nose against the workpiece, pull the trigger and the shell will drive the fastener directly into the concrete.
How long will pressure treated wood last in cement?
40 years
Do pressure treated posts rot in concrete?
Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. … This allows any moisture that gets between the concrete and the bottom of the post to percolate through the gravel and away from the bottom of the post.
Can you put pressure treated wood directly on concrete?
YES. Any exterior concrete that is in contact with earth may wick moisture. Thus, it is required to place pressure treated wood directly against the concrete if one wishes next to build off that concrete with untreated wood. … Next you may place your normal untreated wood floor plate on top of that pressure treated wood.
Will pressure treated wood rot if buried?
Pressure-Treated Wood Makes the Grade Pressure-treated wood in contact with the ground needs the most protection, and will rot in just a few years if you use the wrong grade. … If your wood will touch the ground or be buried, you should get the highest grade you can, up to .
[advanced_iframe use_shortcode_attributes_only=”true” src=”about:blank” height=”800″ width=”800″ change_parent_links_target=”a#link1″ show_iframe_as_layer=”external” enable_ios_mobile_scolling=”true”]
Spread the word ! Don’t forget to share.