As a general rule, component speakers are going to sound better than coaxial speakers, however there are a few tricks that can be helpful to getting the best sound quality out of each type.
Also Which is best coaxial or component speakers?
Roughly speaking, component speakers are generally considered to be the superior type. … On the other hand, component speakers allow for a ton of customization. They also tend to have better sound when they’re around the same price point, but they’re a lot more “fiddly” than coaxial speakers.
Subsequently, What is the difference between a coaxial and component speaker? Coaxial speakers are simply car speaker systems in which all the components are combined in one structure. … Most coaxials have simple, in-built crossovers. View component car speakers as a system with separate drivers. This means you can install different drivers (components) at various locations in your car.
Can you mix coaxial and component speakers? Mixing them up will only hurt stereo imaging and overall freq response. Second, 2 tweeters up front will be TOO much. You could just cut the lead to the coax tweeter, but you will still be running a crossover not suited to the 6.5″ midbass.
Can you run component speakers without an amp?
Can You Use Component Speakers Without an Amp? In a word, yes. Component car speakers can be powered without an outboard (external) power amplifier, and this would be achieved by hooking them directly up to the speaker-level outputs of a car radio/receiver/head unit.
What does coaxial mean in speakers?
A coaxial loudspeaker is a loudspeaker system in which the individual driver units radiate sound from the same point or axis.
Do you need an amp for coaxial speakers?
The truth is that you don’t need an amplifier for coaxial speakers. However, you’ll get even better sound, lower distortion, and potentially more enjoyment (and more volume) out of them if you use one. Car and home receivers have enough power to drive coaxial speakers with fairly good volume and clarity up to a point.
What is a coaxial speaker cable?
Coax or coaxial cable is familiar to most people as the wire that you use to connect cable to your television. … While its thickness and lack of flexibility does present wire management problems, it can be easily used to connect speakers to an audio receiver in a pinch.
Can you mix 2 way and 3 way speakers?
You could combine a two-way speaker consisting of a sub-woofer and a tweeter, with a three-way middle, tweeter, and super tweeter combination. However, that’s pretty much where it ends. Component speakers, on the other hand, are infinitely customizable.
Do coaxial speakers need crossover?
If your car audio system uses coaxial speakers, you probably don’t need an additional crossover. … Even if you add an amplifier into the mix, the built-in speaker crossovers should be more than sufficient. However, you may need a crossover if you add an amplifier and a subwoofer to that type of system.
Is amplifier necessary for speakers?
Speakers are quite remarkable in their ability to convert electrical audio signals into sound waves for our listening pleasure (or displeasure). Speakers of all sizes, from built-in smartphones to live sound subwoofers, require amplifiers.
Can you use component speakers without crossover?
It is a component set meant to run the two speakers together so that they actually sound good. Odds are your head unit will see a more or less than a 2ohm load without the crossover at certain frequency’s. Use the crossovers and save yourself a headache later.
Do you need an amp for aftermarket speakers?
A: In most cases, yes. Aftermarket speakers will certainly sound better with a little more juice, but most of our speakers will sound just fine with factory power. … Low-efficiency speakers can sound great, but they’ll need a high-powered receiver or amplifier for energy.
What’s the difference between midrange and coaxial speakers?
Are coaxial speakers and midrange speakers the same? Nope, not at all. Coaxial speakers are basically what comes stock standard in a car off the manufacturing belt – which means that they can produce a full range of sound. … Mid-range speakers are usually cone shaped and are part of what is known as component speakers.
What do you mean by coaxial?
In geometry, coaxial means that several three-dimensional linear or planar forms share a common axis. The two-dimensional analog is concentric. Common examples: A coaxial cable is a three-dimensional linear structure.
Do all speakers need an amp?
So, the answer is no. Powered speakers don’t need an amplifier. The terms powered and active speakers are often used interchangeably, but there is actually a difference between them. In a pair of powered speakers, there is usually only one amplifier that is built into one of the speakers.
Can coaxial cables be used for audio?
A digital coax cable is a type of cable that can transmit pretty much any digital or electrical signal, but are most commonly used for transmitting audio and video signals. … A digital coaxial interconnector is similar to that of an RCA cable, but the digital cable carries and electrical instead of an analog signal.
Is RCA cable same as coaxial digital?
A Digital Coaxial connection uses a cable that has RCA-type connectors. This digital coaxial cable is different from the standard RCA cable in that it is designed to handle the wider frequency bandwidth of the digital audio bit stream.
Are 2 or 3 way speakers better?
In terms of overall audio quality and fidelity to source signal, a 2-Way speaker is going to provide better clarity and quality than a 3-Way Speaker.
Do front and rear speakers have to match?
The front speakers should match each other, and the rear speakers should be a set, but the front and rear do not have to match. … It is better to ensure that your front speakers match one another in your surround sound system for these reasons.
What the difference between 2 way and 3 way speakers?
A 2-way speaker has two types of drivers which are known as a woofer and tweeter. The woofer is a speaker built exclusively for low-frequency sounds, while the tweeter is designed for high-frequency sounds. A 3-way speaker generates sound from three individual devices known as the mid-range, woofer and tweeter drivers.
Are speaker crossovers necessary?
Why Do You Need A Crossover? Every audio system, including the one in your car, needs a crossover to direct sound to the correct driver. Tweeters, woofers and subs should get high, mid and low frequencies respectively. Every full-range speaker has a crossover network inside.
Do I need a crossover for powered speakers?
Every speaker system needs a crossover of some type. … If you want to run an “active” system, however, you’ll need a more sophisticated crossover. In an active sound system each driver (tweeter, woofer, sub) has its own channel of amplification.